What conditions need to be met for the design of plastic mold cooling water

2019-12-21
First, the water transport margin and product material margin are generally not less than 10MM, as much as possible between 10MM-12MM; alloy mold is generally 25MM;  

Second, the water transport margin and the setting margin of the pins, thimbles, barrels, and inserts are as follows:

① For inner molds below 200MM, the water transport margin and the setting margin of pins, thimbles, barrels and inserts shall not be less than 3.5MM:

② For inner molds larger than 200MM-400MM, the water transport margin and the setting margin of pins, thimbles, barrels, and inserts should not be less than 4MM;

③ For internal molds larger than 200MM-400MM, the margin of water transport and the margin of the setting pins, thimbles, barrels and inserts shall not be less than 4MM

④ For inner molds larger than 400MM-600MM, the margin of water transport and the margin of setting pins, thimbles, barrels, and inserts shall not be less than 5MM

⑤ For inner molds larger than 600MM, the water transport margin and the setting margin of the pins, thimbles, barrels, and inserts shall not be less than 8MM;

3.The water transport and gas cap, and the hydraulic circuit shall not be less than 8MM;
plastic mold design

Fourth, the water transport side and the pouting side to avoid the air are not less than 8MM: 5.The

water transport side and the inner mold side are not less than 10MM;

Design of distance between water and water in the same direction:

① When the two pipe joints are in the same direction, the closest distance between the centers is not less than 38MM;

② When the pipe joint and the throat plug are in the same direction, the closest distance to the center is not less than 25MM;

③ When the two throat plugs are in the same direction, the closest distance between the centers is not less than 20MM;

④, large die area is larger fill level, carrying water from the same direction, from the center and generally 60MM;

seven, not less than 2MM between the impermeable sheet gasket grooves edges; not less than 5MM between glottal and glottal;

eight , Each transport water circuit generally no more than eight spacers in series, (U.S. fishing Aberdeen customer no more than six spacers in series;)

nine, when the insert design of the cooling water, and the water transport material insert bit nearest distance keeping 5MM ; Water transport and insert side is not less than 3.5MM.

Related Products

Hot tags: china mold maker,taizhou,huangyan, suppliers, manufacturers, factory, maker,customized